| Peer-Reviewed

Modelling and Simulation of the Multi-effect/Thermal Vapor Compression Distillation Process

Received: 14 September 2020     Accepted: 29 September 2020     Published: 12 October 2020
Views:       Downloads:
Abstract

The Multi-effect distillation (MED) associated with thermal vapor compression (TVC) process has recently been applied for a number of desalination plants in the GCC countries and emerged as a strong competitor to the multistage flash distillation (MSF) process. The MED/TVC desalination process is characterized by low power consumption compared to the MSF process. It is currently operated at low TBT of 65°C to avoid scale formation compared to MSF technology which operate at top brine temperature of 110°C, this lead to lower tendency to scale formation and less fouling risk. The use of more efficient pretreatment to MED/TVC desalination plants such as nano-filtration or high performance additive antiscalant would allow operating MED at higher TBT which allow increasing the performance ratio. A simulation steady-state program has been established to analyze the thermodynamic behavior of parallel feed flow MED/TVC unit at a wide range of TBT from 65°C up to 125°C and different number of effects with different condition of motive steam pressure on the performance ratio, and specific heat transfer and therefore the best design of MED for the future different design options were considered to optimize the operational of MED system to enhance the economics and performance of MED technology.

Published in International Journal of Mechanical Engineering and Applications (Volume 8, Issue 4)
DOI 10.11648/j.ijmea.20200804.12
Page(s) 103-110
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2020. Published by Science Publishing Group

Keywords

MED-TVC, Desalination, Simulation, Heat and Mass Balance

References
[1] Darwish, M. A. and A. Alsairafi, Technical comparison between TVC/MEB and MSF. Desalination, 2004. 170 (3): p. 223-239.
[2] Emmermann, D., An advanced barge mounted VTE/VC for the desalination of seawater. Desalination, 1981. 38: p. 13-20.
[3] agency, I. a. e., Desalination Economic Evaluation Program. 2000.
[4] El-Nashar, A. M., Predicting part load performance of small MED evaporators - a simple simulation program and its experimental verification. Desalination, 2000. 130 (3): p. 217-234.
[5] Al-Juwayhel, F., H. El-Dessouky, and H. Ettouney, Analysis of single-effect evaporator desalination systems combined with vapor compression heat pumps. Desalination, 1997. 114 (3): p. 253-275.
[6] Al-Sahali, M. and H. Ettouney, Developments in thermal desalination processes: Design, energy, and costing aspects. Desalination, 2007. 214 (1-3): p. 227-240.
[7] Zhe Dong, et al., Dynamical modeling and simulation analysis of a nuclear desalination plantbased on the MED-TVC process. Desalination,2019. 456: p.121-135.
[8] Nafey, A. S., et al., Exergy And Thermo-Economics Investigation Of Multi Effect Evaporation (Mee) And Hybrid Multi Effect Evaporation – Multi Stage Flash (Mee-Msf) Systems, in Ninth International Water Technology Conference. 2005: Sharm El-Sheikh, Egypt.
[9] El-Dessouky, H. T., H. M. Ettouney, and F. Al-Juwayhel, Multiple Effect Evaporation-Vapour Compression Desalination Processes. Chemical Engineering Research and Design, 2000. 78 (4): p. 662-676.
[10] Y. Guo, et al., Effects of preheater arrangement on performance of MED desalination system. Desalination,2020. 496: 114702.
[11] Ameri, M., et al., Effect of design parameters on multi-effect desalinationsystem specifications. Desalination, 2009. 245 (1-3): p. 266-283.
[12] Kamali, R. K. and S. Mohebinia, Experience of design and optimization of multi-effects desalination systems in Iran. Desalination, 2008. 222 (1-3): p. 639-645.
[13] Aly, N. H. and A. K. El-Figi, Thermal performance of seawater desalination systems. Desalination, 2003. 158 (1-3): p. 127-142.
[14] Choi, H.-S., et al., Performance improvement of multiple-effect distiller with thermal vapor compression system by exergy analysis. Desalination, 2005. 182 (1-3): p. 239-249.
[15] Alasfour, F. N., M. A. Darwish, and A. O. Bin Amer, Thermal analysis of ME-TVC+MEE desalination systems. Desalination, 2005. 174 (1): p. 39-61.
[16] Darwish, M. A. and H. El-Dessouky, The heat recovery thermal vapour-compression desalting system: A comparison with other thermal desalination processes. Applied Thermal Engineering, 1996. 16 (6): p. 523-537.
[17] Hamed, O. A., Thermal assessment of a multiple effect boiling (MEB) desalination system. Desalination, 1992. 86 (3): p. 325-339.
[18] Hamed, O. A., et al., Thermal performance and exergy analysis of a thermal vapor compression desalination system. Energy Conversion and Management, 1996. 37 (4): p. 379-387.
[19] Al-Najem, N. M., M. A. Darwish, and F. A. Youssef, Thermovapor compression desalters: energy and availability - Analysis of single- and multi-effect systems. Desalination, 1997. 110 (3): p. 223-238.
[20] Kouhikamali, R. and M. M. S. M, Process investigation of different locations of thermo-compressor suction in MED†TVC plants. Desalination. 280 (13): p. 134-138.
[21] K. A. Khalid, M. A. Antar, A. Khalifa, O. A. Hamed, Allocation of thermal vapour compressor in multi effect desalination systems with different feed configurations, Desalination 426 (2018) 164-173.
[22] Ettouney, H., Visual basic computer package for thermal and membrane desalination processes. Desalination, 2004. 165: p. 393-408.
[23] Amer, A., Development and optimization of ME-TVC desalination system. Desalination, 2009. 249 (3): p. 1315-1331.
[24] El-Dessouky, H. T. and H. M. Ettouney, Multiple-effect evaporation desalination systems. thermal analysis. Desalination, 1999. 125 (1-3): p. 259-276.
[25] Hassan, A. S. and M. A. Darwish, Performance of thermal vapor compression. Desalination. 335 (1): p. 41-46.
[26] El-Dessouky H. T. and H. M. Ettouney, Fundamentals of Salt Water Desalination. 2002: ELSEVIER.
[27] El-Allawy, M. Predictive simulation of the performance of med/tvc desalination distiller. in IDA World Congress, International Desalination Association, Bahamas. 2003.
[28] Younggeun Lee, Osman Ahmed Hamed, Amr Mohammad Mahmoud, Khalid Bamardouf, Sultan Ahmed, Byungsung Park, Abdulaziz Suliman Al-Jamhan, A Demonstration of High Temperature MED-TVC Desalination Technology in the Gulf Area, American Journal of Chemical Engineering. Vol. 7, No. 2, 2019, pp. 57-64. doi: 10.11648/j.ajche.20190702.11
Cite This Article
  • APA Style

    Khalid Bamardouf, Osman Ahmed Hamed, Amro Mohammed Mahmoud. (2020). Modelling and Simulation of the Multi-effect/Thermal Vapor Compression Distillation Process. International Journal of Mechanical Engineering and Applications, 8(4), 103-110. https://doi.org/10.11648/j.ijmea.20200804.12

    Copy | Download

    ACS Style

    Khalid Bamardouf; Osman Ahmed Hamed; Amro Mohammed Mahmoud. Modelling and Simulation of the Multi-effect/Thermal Vapor Compression Distillation Process. Int. J. Mech. Eng. Appl. 2020, 8(4), 103-110. doi: 10.11648/j.ijmea.20200804.12

    Copy | Download

    AMA Style

    Khalid Bamardouf, Osman Ahmed Hamed, Amro Mohammed Mahmoud. Modelling and Simulation of the Multi-effect/Thermal Vapor Compression Distillation Process. Int J Mech Eng Appl. 2020;8(4):103-110. doi: 10.11648/j.ijmea.20200804.12

    Copy | Download

  • @article{10.11648/j.ijmea.20200804.12,
      author = {Khalid Bamardouf and Osman Ahmed Hamed and Amro Mohammed Mahmoud},
      title = {Modelling and Simulation of the Multi-effect/Thermal Vapor Compression Distillation Process},
      journal = {International Journal of Mechanical Engineering and Applications},
      volume = {8},
      number = {4},
      pages = {103-110},
      doi = {10.11648/j.ijmea.20200804.12},
      url = {https://doi.org/10.11648/j.ijmea.20200804.12},
      eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.ijmea.20200804.12},
      abstract = {The Multi-effect distillation (MED) associated with thermal vapor compression (TVC) process has recently been applied for a number of desalination plants in the GCC countries and emerged as a strong competitor to the multistage flash distillation (MSF) process. The MED/TVC desalination process is characterized by low power consumption compared to the MSF process. It is currently operated at low TBT of 65°C to avoid scale formation compared to MSF technology which operate at top brine temperature of 110°C, this lead to lower tendency to scale formation and less fouling risk. The use of more efficient pretreatment to MED/TVC desalination plants such as nano-filtration or high performance additive antiscalant would allow operating MED at higher TBT which allow increasing the performance ratio. A simulation steady-state program has been established to analyze the thermodynamic behavior of parallel feed flow MED/TVC unit at a wide range of TBT from 65°C up to 125°C and different number of effects with different condition of motive steam pressure on the performance ratio, and specific heat transfer and therefore the best design of MED for the future different design options were considered to optimize the operational of MED system to enhance the economics and performance of MED technology.},
     year = {2020}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - Modelling and Simulation of the Multi-effect/Thermal Vapor Compression Distillation Process
    AU  - Khalid Bamardouf
    AU  - Osman Ahmed Hamed
    AU  - Amro Mohammed Mahmoud
    Y1  - 2020/10/12
    PY  - 2020
    N1  - https://doi.org/10.11648/j.ijmea.20200804.12
    DO  - 10.11648/j.ijmea.20200804.12
    T2  - International Journal of Mechanical Engineering and Applications
    JF  - International Journal of Mechanical Engineering and Applications
    JO  - International Journal of Mechanical Engineering and Applications
    SP  - 103
    EP  - 110
    PB  - Science Publishing Group
    SN  - 2330-0248
    UR  - https://doi.org/10.11648/j.ijmea.20200804.12
    AB  - The Multi-effect distillation (MED) associated with thermal vapor compression (TVC) process has recently been applied for a number of desalination plants in the GCC countries and emerged as a strong competitor to the multistage flash distillation (MSF) process. The MED/TVC desalination process is characterized by low power consumption compared to the MSF process. It is currently operated at low TBT of 65°C to avoid scale formation compared to MSF technology which operate at top brine temperature of 110°C, this lead to lower tendency to scale formation and less fouling risk. The use of more efficient pretreatment to MED/TVC desalination plants such as nano-filtration or high performance additive antiscalant would allow operating MED at higher TBT which allow increasing the performance ratio. A simulation steady-state program has been established to analyze the thermodynamic behavior of parallel feed flow MED/TVC unit at a wide range of TBT from 65°C up to 125°C and different number of effects with different condition of motive steam pressure on the performance ratio, and specific heat transfer and therefore the best design of MED for the future different design options were considered to optimize the operational of MED system to enhance the economics and performance of MED technology.
    VL  - 8
    IS  - 4
    ER  - 

    Copy | Download

Author Information
  • Thermal Department, Desalination Technologies Research Institute (DTRI-SWCC), Jubail, Saudi Arabia

  • Thermal Department, Desalination Technologies Research Institute (DTRI-SWCC), Jubail, Saudi Arabia

  • Thermal Department, Desalination Technologies Research Institute (DTRI-SWCC), Jubail, Saudi Arabia

  • Sections