| Peer-Reviewed

Eco Concrete Characterization Using Steel Slag and Ground Granulated Blast Furnace Slag as Partial Replacement of Sand and Cement Respectively

Received: 22 July 2020     Accepted: 4 August 2020     Published: 19 November 2020
Views:       Downloads:
Abstract

The waste products of the factory mainly steel slag and GGBFS (ground granulated blast furnace slag) are used and recycled to gain concrete of different requirements related to strength and durability. In this research, it is intended to examine the impact of ground granulated blast furnace slag and steel slag replacement for cement and fine aggregate respectively. Both materials are taken from a factory of reinforcement bars which is located around Akaki kality sub-city, known as Akaki steel factory. The research additionally addresses X-ray diffraction (XRD), Scanning electron microscope techniques (SEM), and chemical composition of major oxides and minor oxides of the blast furnace slag. The main objective of this research targets in investigating an experimental aspect of replacing by-products of steel slag and ground granulated blast furnace slag partially on concrete production. It addresses the issue of a more expedite and urgent issue of our globalized world, climate change by replacing part of the concrete with these waste products. The followings are the main steps to carry out the researchAnalysis of properties of materials used as steel slag and ground granulated blast furnace slag. Blast furnace slag and steel slag mixed concrete mix design for partial substitution of cement and fine aggregate respectively. Find out the optimum replacement level of steel slag and that of ground granulated blast furnace slag in concrete. The thesis puts forward an experimental based analysis to determine the extent to which the industrial waste materials play a role in partial substitution of fine aggregate and cement in the preparation of concrete. From the experiments demonstrated flexural, tensile, and compressive strength of concrete is higher when GGBFS is replaced up to 5% of the cement and that of steel slag up to 30% of the sand.

Published in Landscape Architecture and Regional Planning (Volume 5, Issue 4)
DOI 10.11648/j.larp.20200504.11
Page(s) 61-66
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2020. Published by Science Publishing Group

Keywords

Steel Slag, Compressive Strength, Flexural Strength, Split Tensile Strength, Ground Granulated Blast Furnace Slag, XRD, SEM

References
[1] Dash, M. K., Patro, S. K. & Rath, A. K. – A review. Sustainable use of Ind. as Partial Replace. fine Aggreg. Prep. Concr. 5, 484–516 (2016).
[2] Shetty, M.. concrete technology. (2009).
[3] B. Kaviya. R, Arjun, R. Study on Partial Replacement of Cement By Ground Granulated. Int. J. Pure Appl. Math. 116, 411–416 (2017).
[4] M, A. & MARIA, S. Eco-friendly concrete with rise husk ash. Int. J. Appl. engineering Res. 9, 5471–5489 (2014).
[5] Kadam, P. L. et al. of concrete. 7, 1534–1537 (2016).
[6] Wang, P. et al. Test Study on Cube Compressive Strength of Recycled Lightweight Aggregate Concrete. 630–634 (2016) doi:10.2991/ame-16.2016.105.
[7] Liu, J. & Wang, D. Application of Ground Granulate Blast Furnace Slag-Steel Slag Composite Binder in a Massive Concrete Structure under Severe Sulphate Attack. Adv. Mater. Sci. Eng. 2017, (2017).
[8] Tamboli, professor M. A.. compressive strength of steel slag and artificial sand in concrete. 6, 0976–6316 (2015).
[9] Rajan, S. study on strength properties of concrete by partial replacement of sand by steel slag. IJETS ISSN01, 2349–3948 (2014).
[10] P. s, K. & DR. r. Malathy. Utilization of steel slag in concrete as a partial replacement material for fine aggregates. 3, (2014).
[11] Seo, M.., Kim, T., G. Hong & H. Kim. on-site measurements of CO2 emissions during the construction phase of a building complex. (2016)
[12] J. Lizarazo-marriaga. effect of steel slag and portland cement in the rate of hydration and strength of blast furnace slag pastes. 23, (2011).
[13] Netinger Grubeša, I., Barišic, I., Fucic, A. & Bansode, S. S. Characteristics and uses of steel slag in building construction. Characteristics and Uses of Steel Slag in Building Construction (2016). doi:10.1016/c2014-0-03994-9.
[14] F. Moody, M. structural biology using electrons and x-rays, 341-347 (2011).
[15] Zhou, W., Apkarian, R., Wang, Z. L. & Joy, D. Fundamentals of scanning electron microscopy (SEM). Scanning Microsc. Nanotechnol. Tech. Appl. 1–40 (2007) doi: 10.1007/978-0-387-39620-0_1.
[16] Arjun, S., Hemalatha, T. & Rajasekaran, C. Partial replacement of steel slag aggregates in concrete as fine aggregates (induction blast furnace slag). Lecture Notes in Civil Engineering vol. 25 (Springer Singapore, 2019).
[17] Duran Atiş, C. & Bilim, C. Wet and dry-cured compressive strength of concrete containing ground granulated blast-furnace slag. Build. Environ. 42, 3060–3065 (2007).
[18] S. V. B Reddy, Dr. P. Srinivasa Experimental Studies on compressive strength of ternary blended concretes at different levels of micro silica and GGBFS (2016).
[19] AA, R. & Vm, M. effect of Curing on the compressive strength, resistance to Chloride-ion penetration and porosity of concretes incorporating slag, fly ash or silica fume cement and concrete composites. 17, 33–125 (1995).
[20] J. Bensted & P. Barnes. structure and performance of cement. CRC Press2, (2001).
[21] Huang, X., Wang, Z., Liu, Y., Hu, W. & Ni, W. On the use of blast furnace slag and steel slag in the preparation of green artificial reef concrete. Constr. Build. Mater. 112, 241–246 (2016).
[22] G. I, G. et al. scanning electron microscopy, and x-ray microanalysis. ISBN (1981).
[23] Y. Liu, H. Fang & L. Lu. research progress on the techniques of treatment and comprehensive utilization of steel slag. Chem. eng.equip. 09 190–192 (2014).
[24] M. S. Shetty. concrete technology theory and practice. (2005).
[25] Dave, N., Misra, A. K., Srivastava, A. & Kaushik, S. K. Setting time and standard consistency of quaternary binders: The influence of cementitious material addition and mixing. Int. J. Sustain. Built Environ. 6, 30–36 (2017).
[26] D. Breton. contribution to the formation mechanism of the transition zone between rock-cement paste and cement concrete. 23, 335–346 (1993).
[27] M. S. Imbabi, C. Carrigan, S. McKenna, Trends and development in green cement and concrete technology, Int. J. Sustain. Built Environ. 1, 194 (2012).
[28] E. Yogarajah, T. Nawa, T. Igarashi, Physical, chemical, and mineralogical characteristics of blast furnace slag on the durability of concrete. 060-8628 (2018).
[29] B. A. Zulu, S. Miyazawa, and N. Nito 3 Properties of Blast-Furnace Slag Cement Concrete Subjected to Accelerated Curing 31 October (2019).
Cite This Article
  • APA Style

    Mekides Damena, Shanmuga Vadivu. (2020). Eco Concrete Characterization Using Steel Slag and Ground Granulated Blast Furnace Slag as Partial Replacement of Sand and Cement Respectively. Landscape Architecture and Regional Planning, 5(4), 61-66. https://doi.org/10.11648/j.larp.20200504.11

    Copy | Download

    ACS Style

    Mekides Damena; Shanmuga Vadivu. Eco Concrete Characterization Using Steel Slag and Ground Granulated Blast Furnace Slag as Partial Replacement of Sand and Cement Respectively. Landsc. Archit. Reg. Plan. 2020, 5(4), 61-66. doi: 10.11648/j.larp.20200504.11

    Copy | Download

    AMA Style

    Mekides Damena, Shanmuga Vadivu. Eco Concrete Characterization Using Steel Slag and Ground Granulated Blast Furnace Slag as Partial Replacement of Sand and Cement Respectively. Landsc Archit Reg Plan. 2020;5(4):61-66. doi: 10.11648/j.larp.20200504.11

    Copy | Download

  • @article{10.11648/j.larp.20200504.11,
      author = {Mekides Damena and Shanmuga Vadivu},
      title = {Eco Concrete Characterization Using Steel Slag and Ground Granulated Blast Furnace Slag as Partial Replacement of Sand and Cement Respectively},
      journal = {Landscape Architecture and Regional Planning},
      volume = {5},
      number = {4},
      pages = {61-66},
      doi = {10.11648/j.larp.20200504.11},
      url = {https://doi.org/10.11648/j.larp.20200504.11},
      eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.larp.20200504.11},
      abstract = {The waste products of the factory mainly steel slag and GGBFS (ground granulated blast furnace slag) are used and recycled to gain concrete of different requirements related to strength and durability. In this research, it is intended to examine the impact of ground granulated blast furnace slag and steel slag replacement for cement and fine aggregate respectively. Both materials are taken from a factory of reinforcement bars which is located around Akaki kality sub-city, known as Akaki steel factory. The research additionally addresses X-ray diffraction (XRD), Scanning electron microscope techniques (SEM), and chemical composition of major oxides and minor oxides of the blast furnace slag.  The main objective of this research targets in investigating an experimental aspect of replacing by-products of steel slag and ground granulated blast furnace slag partially on concrete production. It addresses the issue of a more expedite and urgent issue of our globalized world, climate change by replacing part of the concrete with these waste products. The followings are the main steps to carry out the researchAnalysis of properties of materials used as steel slag and ground granulated blast furnace slag. Blast furnace slag and steel slag mixed concrete mix design for partial substitution of cement and fine aggregate respectively. Find out the optimum replacement level of steel slag and that of ground granulated blast furnace slag in concrete. The thesis puts forward an experimental based analysis to determine the extent to which the industrial waste materials play a role in partial substitution of fine aggregate and cement in the preparation of concrete. From the experiments demonstrated flexural, tensile, and compressive strength of concrete is higher when GGBFS is replaced up to 5% of the cement and that of steel slag up to 30% of the sand.},
     year = {2020}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - Eco Concrete Characterization Using Steel Slag and Ground Granulated Blast Furnace Slag as Partial Replacement of Sand and Cement Respectively
    AU  - Mekides Damena
    AU  - Shanmuga Vadivu
    Y1  - 2020/11/19
    PY  - 2020
    N1  - https://doi.org/10.11648/j.larp.20200504.11
    DO  - 10.11648/j.larp.20200504.11
    T2  - Landscape Architecture and Regional Planning
    JF  - Landscape Architecture and Regional Planning
    JO  - Landscape Architecture and Regional Planning
    SP  - 61
    EP  - 66
    PB  - Science Publishing Group
    SN  - 2637-4374
    UR  - https://doi.org/10.11648/j.larp.20200504.11
    AB  - The waste products of the factory mainly steel slag and GGBFS (ground granulated blast furnace slag) are used and recycled to gain concrete of different requirements related to strength and durability. In this research, it is intended to examine the impact of ground granulated blast furnace slag and steel slag replacement for cement and fine aggregate respectively. Both materials are taken from a factory of reinforcement bars which is located around Akaki kality sub-city, known as Akaki steel factory. The research additionally addresses X-ray diffraction (XRD), Scanning electron microscope techniques (SEM), and chemical composition of major oxides and minor oxides of the blast furnace slag.  The main objective of this research targets in investigating an experimental aspect of replacing by-products of steel slag and ground granulated blast furnace slag partially on concrete production. It addresses the issue of a more expedite and urgent issue of our globalized world, climate change by replacing part of the concrete with these waste products. The followings are the main steps to carry out the researchAnalysis of properties of materials used as steel slag and ground granulated blast furnace slag. Blast furnace slag and steel slag mixed concrete mix design for partial substitution of cement and fine aggregate respectively. Find out the optimum replacement level of steel slag and that of ground granulated blast furnace slag in concrete. The thesis puts forward an experimental based analysis to determine the extent to which the industrial waste materials play a role in partial substitution of fine aggregate and cement in the preparation of concrete. From the experiments demonstrated flexural, tensile, and compressive strength of concrete is higher when GGBFS is replaced up to 5% of the cement and that of steel slag up to 30% of the sand.
    VL  - 5
    IS  - 4
    ER  - 

    Copy | Download

Author Information
  • Construction Technology and Management, College of Architecture and Civil Engineering, Addis Ababa Science and Technology University, Addis Ababa, Ethiopia

  • Department of Civil Engineering College of Architecture and Civil Engineering Addis Ababa Science and Technology University, Addis Ababa, Ethiopia

  • Sections